-
DIP TUBES
Continuously Lined PTFE Dip Pipe (Class 150)
Standard Housing Materials:
Pipe: 1" to 8" (Sch. 40), 10" to 12" (Sch. 30)
CS ASTM A106 Grade B
Also available: 304/316 Stainless Steel
Standard Flange Materials:
As per ASTM A105
Dimension as per ANSI B 16.5 Class 150Standard Linear Materials:
PTFE as per ASTM D 4895
Lining and testing as per ASTM F1545-15a
Exterior Finish:
Standard: Two Layers of epoxy corrosion resistant primer
Special paint or blast profile can be applied for an
additional charge.Size (inch) Ordering Codes S (mm) Vessel Flange
RangeFace to Face
(mm)Maximum
Immersion (mm)Lining
MaterialHousing
Material1" LPS-1040-1 3.1 1.5" - 24" 150 5500 PTFE Fabricated
Steel1.5" LPS-1040-1.5 3.2 2" - 24" 2" LPS-1040-2 3.8 3" - 24" 3" LPS-1040-3 4.0 4" - 24" 4" LPS-1040-4 4.0 1.5" - 24" 6" LPS-1040-6 5.0 1.5" - 24" 8" LPS-1040-8 5.0 1.5" - 24" 10" LPS-1040-10 7.0 1.5" - 24" 2500 12" LPS-1040-12 7.0 1.5" - 24" - DufLine Dip Pipes have a wide array of uses. Typically, they are used to charge a reactor below the liquid level,
to extract samples from the reactor as part of sampling systems or to drain liquid from a vessel without the
need of side or bottom outlet. - DufLine Dip Pipes are manufactured from carbon steel fabricated construction with a continuously lined paste
extrusion PTFE liner. Having all wetted parts made of PTFE gives excellent corrosion resistance. - Dip pipes can be supplied straight or curved to angle liquor to the side of the reactor etc.
- Powerful agitator blades can create a lot of stress on components installed in a reactor vessel. Before we supply
any Dip Pipes, we thoroughly check that the mechanical strength of the Dip Pipe will be sound against specific
process conditions. This is extremely important to save on very costly breakages.
For details on sizes 14" and above please contact DuFlon
5238 Rev 00 dt 17th Jan 2017
BACK TOLPS ANSI STANDARDS - DufLine Dip Pipes have a wide array of uses. Typically, they are used to charge a reactor below the liquid level,